DISPLAY & GIFTING

HueForge Lite Display Stand — 60 mm

A compact stand for displaying HueForge artwork.

White lightweight HueForge stand with open triangular sides — Supplied product presentation image of the white Lite stand.

About the design

The original stand held the artwork well, but used more material and took longer to print than I wanted. This version keeps the 66.4° viewing angle and open retaining cradle, with a 46 mm backing and open sides in a compact, one-piece 60 mm stand.

I have printed four in black and three in white. The 60 mm version has held a 200 mm HueForge, including a bordered print. There is no assembly and no sliding mechanism.

My K2 Pro slice at 0.20 mm estimated 36 minutes 50 seconds and 17.52 g. Those are slicer estimates for that setup, not a promise for every printer.

See the original stand for the earlier design.

Check the listing for the supported artwork thickness and print setup before choosing it for your piece.

View on Creality Cloud ↗

If you print this, please download it from the original listing. It supports my creator page and keeps the files and feedback together.

A closer look

Black lightweight HueForge stand with open triangular sides — Supplied product presentation image of the black Lite stand.

Pumba portrait in a pale bordered stand — Presentation image: Pumba on display in the bordered stand.

D4Maker website lettering on the white stand rear bar — Supplied detail image: the low rear bar and recessed website lettering.

D4 mark and rear bar on the black Lite stand — Supplied detail image: the side mark and rear bar.